Woodworking can come in handy in many aspects of life. You do not have to make it a full time occupation, but you may want to enhance your home or do a building project with the children in the future. Keep reading to find out more.

Consider making sanding blocks yourself that you can reuse time and again. Use a scrap of 3/4″ plywood to cut six blocks, one for each sandpaper grit you need. They should be about 4.75″ x 2.5″. Spray adhesive on your blocks and also the cork square tile. Stick a block to the cork, making sure to cut the cork flush with a utility knife. Get a sandpaper sheet, spray it with adhesive, and then apply it to each of your cork blocks; they need to be face down. Finally, trim the sandpaper and label each block.

Use stair gauges for crosscut guides. Clamp them on the carpenter’s square. Then use a pencil to mark the notches. Put them on your carpenter’s square guide for a great cut.

You should stir stains and finishes before using them. They should never be shaken. These can settle can must be stirred. Shaking can cause bubbles and lead to uneven mixing. Be sure to continue stirring until everything that has settled is blended in evenly.

Choose the right type of wood for the project that you are doing. Different types of wood can handle different levels of stresses. Some are stronger than others. Always research the type of wood you want to work with before you get started on your new project.

Ask for a how-to demonstration when you rent a new tool. Many times, they have specialists that will show you how to use the tool properly and safely. Also, ask if they include a handout explaining tips on using the tool.

Your woodworking shop needs a stair gauge. They are used often to layout jacks for stairs, but they can also be clamped to your carpenter’s square. That way, it is possible to make a carpenters square into a circular saw guide. Using this square will allow you to make cuts that are straight.

It’s great to have a small ruler inside your pocket, but it might fall out if you have to bend. If you purchase a metal ruler, you can keep it in your pocket with a telescoping magnet. The magnet should keep your ruler in the pocket.

If your interior doors have loose hinges, you can simply fix it with a golf tee. Take the door off its hinges, then remove the hinges themselves, then tap the tee into the screw hole. Remove the bit which hangs out and then put the door back into place. The screw has something to bite on with the golf tee.

You now should realize more about the art of woodworking than you knew before. That is going to prove useful some day, since woodworking is something everyone has to do at least once or twice. Make sure to keep reading and learning, and doors will open up for you.